Sig-sauer BLASER R93 Manuale Utente

Instruction manualR93-Manual-english 08.01.2001 16:22 Uhr Seite 1

103. Loading the rifle- Pull back the slide („On safe“)- Open the bolt (see chapter 2.5)- Place a cartridge onto the magazineand press firmly downward

115. Unloading the rifle- Remove your finger from the triggerand point the rifle in a safe direction.- Move the safety slide in the „On Safe“position

12englishThere are 8 caliber groups available (seetable on page 42). When changing thebarrel to a different caliber group, youwill also have to change

138. Changing the bolt headfig.12 fig.13 fig.148.1 Changing the bolt headIt is advisable to have this operationexplained by your gunsmith.- Unload the

- Flip the retaining latch down again andpush it back into its recess so that itsnaps into position (fig. 16).Note: To make this process easier, jiggl

fig.18 fig.19The bolt assembly can only be inserted in the receiver when the warning pin is flush in the bolt rail (fig. 18), indica-ting that the ret

169. Removing / changing the fore-endThe Safari and Match versions of theBlaser R 93 repeating rifle have a special,wide fore-end. Therefore, should y

1710. Trigger assemblyThe Blaser R 93 bolt action rifle is equipped with a light and crisp trigger.The trigger resistance is adjusted at thefactory to

18english- First thumb the front lever (fig. 22)then the rear lever back and down asfar as they can go. If you need to applyeither no force or a lot o

1913.2 Removing the scope- Grasp the rifle with your left hand around the fore-end and scope, steadying the rifle on your upper thigh.- Loosen the two

2Caution ! Please always read this instructionmanual entirely, before using therifle. The rifle may only be passedon together with this instructionman

2014. Caliber group tableMini „MI“:.222 Rem..222 Rem. Mag.Hornet „HO“:.22 HornetStandard „ST“:.22-2505,6x57.243 Win.6 mm Rem.6x62 Frères.25-066,5x556,

2115. CaseThe R 93 together with extra barrel, 2 scopes and accessories for travelling issecurely stowed in a double-shell ABScarrying case with 3 loc

22Safety slide down- uncocked position= safety onFinger recessBolt handleWarning pin ofretaining latchGuide railButt stockBolt stop pin Trigger Trigge

2318. Warranty conditions1. Manufacturer’s warrantyThe warranty of Blaser Jagdwaffen GmbH supp-lements the statutory warranty rights through thedealer

Blaser Jagdwaffen GmbHD-88316 IsnyGERMANYR93-Manual-english 08.01.2001 16:23 Uhr Seite 24

3ContentsPageSafety rules 4 – 511. Assembling, taking down 6 – 712. Safety system and bolt handle lock 8 – 913. Loading the rifle 1014. Firing and rep

4englishSafety rulesYour new Blaser bolt action rifle model R 93 differs from other repeaters througha number of special design features.Although your

5Safety rules- Whenever holding the rifle, alwayspoint the muzzle in a safe direction toensure you neither injure people nordamage property.- Before l

6english1. Assembling, taking down1.1 Assembling- Remove the large allen key (SW 4)from its pocket in the shipping carton.With the barrel screw studs

71. Assembling, taking downfig. 4- Push the magazine down to the bottom of the receiver - with yourthumb - and hold! (fig. 4).- Place both bolt rails

82. Safety system and bolt handle lock2.1 Safety systemThe safety system of the Blaser R 93 boltaction rifle is centered on the uncockedfiring spring:

92. Safety system and bolt handle lockfig. 7 fig. 8 fig. 92.3 Uncocking (»breech in safe position«)- Press with your thumb firmly on thesafety slide t